Jeep Wrangler JK Lift 2" - 6'' Control Arm Correction Brackets JKS

Greggson off road 4x4 shop, offers Control Arm Correction Brackets JKS very high quality.

Durable, high-quality product from JKS

Improve the handling of your lifted Jeep Wrangler JK with JKS front control arm correction brackets.
Designed for use with 2-6" lift kits the brackets improve control arm operating angle to mimic or improve on factory arm angles as well as improve anti-dive during braking.
Lowering the control arm mounting point slightly places the arms closer to the axle mount which corrects caster and geometry caused by the lifted ride height.
Two mounting hole positions correct geometry for given lift heights.
Heavy duty, 1pc, fully boxed 7GA steel brackets install inside the factory upper and lower control arm mounts with the factory hardware.
The fully gusseted design you extra confidence both on and off road.

Specs:
- Reduced control arms angles allow the front suspension to more naturally roll over bumps
- Correct control arm operating angle and mimic factory suspension geometry
- Improve the front drive shaft CV joint operating angles through full wheel travel
- Heavy duty steel construction, double powder coated
- Work with factory and aftermarket adjustable control arms
- Easy, bolt on installation
- Sold in pairs

In the box:
- (2) Control arm correction brackets
- Mounting hardware

Notes:
- Ideal lift range is 2-4,5" but can be used up to 6"
- Requires 2" of front bump stop extension for adequate clearance at full suspension compression (sold separately)

Fits to:
- Jeep Wrangler JK 2 Door (2007-2018)
- Jeep Wrangler JKU 4 Door (2007-2018)

Before ordering the item, we would like to ask you to contact us, as some of the items are not always in stock.